Anyang micro injector manufacturers supply Xiangde experimental micro-injector factory direct Product Name: micro-injector 50μl Package Size: 215mm * 35mm * 20mm Weight Approx: 60g Instructions: 1. Avoid heavy alkaline washing solution, in order to avoid glass corrosion of stainless steel parts and affect weight loss and leakage leakage corrosion. 2, the injector should be soaked before use to pull back and forth several times in the solution inside the bubble tip exhaust, otherwise it will affect the accuracy of analysis and capacity progress cleaned immediately after use to prevent tip clogging or stuck. 3, if there is a stainless steel oxide (black and so on) within the injector when affect normal use, can be dipped in a small amount of soapy water in a stainless steel core stuffed into the back and forth several times to pull within a sampler can be removed, and then wash that can. 4, no deposit liquid micro-injector core pulling capacity indicator shall not exceed the mark if accidentally pulled out, you can re-assembly, you must first unscrew the tip of the nut, and then patiently through the core from a silicon rubber gasket, and then to quasi-tip screw hole on the nut, promoting core, may not be directly in series in order to avoid bending stainless steel wire. 5, the injector tip should not use fire, in order to avoid losing the tip annealing pass stamp capability, in case it is appropriate to plug tip diameter 0.1mm stainless steel wire collusion. Please contact: Name: Zhang Hongbin Tel: 0373-2025480 Mobile: 15903735572 Address: Xinxiang Chemical Road and Victory Road intersection north 200 meters Road East E-mail: xxxdsy@163.com Company Website: http: // www. xdsycl.net